现在位置:首页 » 论文 »

ASME规范案例2605-2在四种温标下的算法转换及工程应用

作者:Kenny Shen ⁄ 时间:2017年11月13日 ⁄ 分类: 论文 评论:0  摘要ASME规范案例2605是在ASME VIII-2的基础上将2.25Cr-1Mo-V钢的疲劳设计温度由371℃扩展为454℃。该案例于20101月进行第一次修订,即ASME规范案例 2605-1,于20156月进行第二次修订,即ASME规范案例2605-2。目前最新版中除了将温度上限从454850)提高到了482900)、在蠕变棘轮的校核中引入了弹性分析来代替非弹性分析之外,还对上版中表1和表1M中的温度单位和相关的公式进行了修正。本文将对ASME规范案例2605-2中的温标修订的相关表格和公式进行解读和探讨,为国内工程设计人员更好的理解规范案例提供参考。

关键词:Code Case 2605蠕变疲劳,兰氏温度,分析设计

 


Abstract: ASME Code Case 2605, as an extension of ASME VIII-2, was extended the design temperature of 2.25Cr-1Mo-V steel from 371℃ to 454℃ in the fatigue design. This Code Case was revised for the first time in January 2010, that is, ASME Code Case 2605-1.The latest version is ASME Code Case 2605-2 which was revised in June 2015. In the latest version, some items are updated and revised, such as the highest applicable temperature from 454℃ (850℉) to 482℃ (900℉) and the elastic analysis instead of inelastic analysis for the creep ratchet checking, but the most important revisions are the temperature units in Table 1 and Table 1M. In this paper, the revision of some incorrect parameters, the temperature units and their corresponding formulas in Code Case 2605-2 and the implementation of the algorithm are presented and discussed, which can provide helpful references for domestic engineering application.


Key words: Code Case 2605, Creep-fatigue, Rankine temperature, Design by analysis

 
本文由Kenny Shen原创或编辑,转载请保留链接【ASME规范案例2605-2在四种温标下的算法转换及工程应用】http://kennyshen.com/?post=83 上一篇: 高温结构完整性评定规程R5的最新进展和发展趋势
下一篇:ASME规范案例2605-2的修订解读及算法实现
目前有 0 条评论